Commission: Judith Edge pair…
This pair of lovely models left a few weeks ago, such is the backlog now on Commission Monday! Both Judith Edge kits and to be supplied in primer…
It was interesting to reflect on the differences in kit design, I presume one early and one more recent from Michael Edge’s hand - that said, no real trouble in assembly. They are fiddly, and not for the beginner but the results are neat and consistent. Running wise, both were supplied with Gibson wheels, Mashima motor and a Branchline gear set. I dislike Gibson wheels - they’re difficult to set an accurately and almost impossible to get on straight but there isn’t an alternative these days. I swapped the Branchlines sets for proper High Level gearboxes. The motors were quite large, so in hindsight it might have been better to put something smaller in them too - especially as sadly I ran out of room and comfidemce to fit the DCC sound my customer requested.
The little Brush runs on coach wheels on brass axles and features compensation. Setting the quartering of the brass fly cranks is a bit of pain, harder certainly than wheels on an axle! Details and parts chosen to represent D2999. Etched plates, lamp irons and buffers assembled but not pictured to aid assembly and wasp striping later. Glazing cut to fit before etches removed from the fret. You learn the hard way with Judith Edge kits - they’re cleanly designed and well etched, but steps work in a similar way each time and it’s difficult to cut the glazing to fit once you’ve started soldering bits together!
The big Barclay is perhaps a slightly older design - build rigid and with effectively four axles to quarter no joke. The clearance on the crank pins is non-existent either, so much that I had to just solder the bushing on backwards for the pin behind the flycranks coupling rod. Again, buffers and fine details left off to aid painting.
Whilst I offer a complete design/source/build/finish service I am happy to offer commissions for just one one or two of these steps, if they they help you move a project forwards. Get in touch to discuss your requirements. Until next time, more soon…
Support my work
I love writing and creating material for the blog. If you enjoy what you read and engage with I would be appreciative of any donation, large or small, to help me keep it advert and restriction free. Alternatively, feel free to buy me a coffee, where regular memberships start from just £1.







Comments
Post a Comment
Thank you for leaving a comment on my blog - I appreciate you taking the time to share your views. If you struggle to log in, please turn off the ‘block cross-site tracking’ setting in your browser.
James.